Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right

Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right
Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right

Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right

1 Pair Tail Light Assembly. Compatible w/Factory Incandescent Tail Light Model Only. Made of materials that meet or exceed OEM requirements.

Condition: 100% Brand New and High Quality. DOT/SAE approved for street legal. For toughness, impact resistance, and heat resistance.

Material: ABS Plastic Housing / Polycarbonate Lens. Professional Installation is Highly Recommended. Installation Instruction is NOT Included.

Undo the screws, clips, or retainer springs that hold the headlight in place. Disconnect the wiring from the assembly. Detach the headlight from the vehicle to replace it with a new one. Fit in the new headlight assembly.

Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed. Reconnect the wiring that was unplugged from the assembly.

Put back the grille and other components that you removed. Seal them back into place. Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from teh wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground. Firstly, locate the adjustment screws on your vehicle. The headlights should be adjusted one at a time.

Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line. The note there will NOT be read. The images shown are not the actual item and are for your reference only. OR, you may choose to have a replacement.

To you as soon as possible with a reply. FEEDBACK IS VERY IMPORTANT TO US. It is impossible to address issues if we do not know about them! Led 3rd brake tail light.

6pcs 4 Inch Round 24-LED Tail Light Reverse Backup Lamp Red For Truck Trailer. 5 Smoke Cab Roof Running Marker Light Cover Lens For Ford F-250 F-350 Super Duty.

LED 3rd Tail Brake Light Cargo Light for 88-98 Chevy Silverado GMC Sierra Chrome. Black LED 3rd Tail Brake Light Cargo Light for 88-98 Chevy Silverado GMC Sierra.

1PCS Wheel Hub Bearing Rear FWD For 2007 2008 2009 2010 2011-14 Mazda CX-9 3.7L. Passenger Side Mirror Glass For VOLVO S80/S40/S50 07-11/C30/C70 08-13/S60/V70.


Full LED Taillights Assembly For 2009-2018 Dodge Ram 1500 2500 3500 Left+Right